Most of the time, businesses would spend a lot of money to purchase their forklifts. It is important, therefore to take good care of your machinery to protect your investment into the long run. It is a good idea to know the procedures that are undertaken during the maintenance and care of this piece of machinery.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is performing. For instance, if there are any misses or knocks, the machinery is defective and this should raise some issues. Also listen carefully for any squealing noise that come from the belts because these noises will provide you with a wealth of information.
Several of the main components needing attention during maintenance comprise the gauges, horn, safety warning devices, the overhead guard and the lights. Any burnt out light bulbs or faulty parts should be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals must be cleaned after the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Every battery cell should be checked so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and then change the filters. The transmission filter, fuel filters and the hydraulic filter have to be regularly replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Check the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, inspect each and every other part of the equipment including the wheels. If any kind of fault or problem is detected, be certain to deal with it immediately in order to make sure the machine is running at its safest and optimum levels.